Precision pipe bending
We bend precision pipes on a mandrel bender - no ovalization, kinks or wall thinning in the bend zone.
In hydraulics the bend often matters more than the joint: every extra fitting is a potential leak and a local pressure drop. Mandrel bending lets you replace several joints with a single bend while keeping the pipe’s full bore.
We produce both one-off assemblies from a sample and series batches to a drawing – with radius and angle control.
What the service includes
- Mandrel bending of precision pipes up to 42 mm in diameter
- Bore retained: no ovalization or wall thinning
- Bending to the customer’s drawing, sketch or sample
- Several bends on one blank with the geometry preserved
- End preparation for fittings: cutting, chamfering, flaring
- One-off assemblies and series batches using tooling
Опишіть задачу - інженер зателефонує впродовж робочого дня та узгодить умови й строк.
Send a request +38 (032) 259-10-60FAQ
We bend pipes up to 42 mm in diameter; for larger diameters we offer fabricated solutions.
Preferable, but a sketch or a sample of the old pipe is enough - we take the geometry ourselves.
Yes, the mandrel tooling supports the wall from inside - ovalization stays within tolerance.
Yes, the only limit is the length of the straight sections between bends.
Yes: cutting to size, chamfering and flaring for the specific connection.
Yes, series batches are made using tooling with first-article inspection.
